Understanding the Toilet Flange
The toilet flange is a critical component that connects the toilet to the waste pipe and secures it in place. It is usually made of PVC or cast iron and is installed on the floor, sitting flush with the finished surface.
Occasionally, however, the flange may end up being too high due to various reasons, including incorrect installation or changes in the flooring height.
Assess the Situation
Before taking any action, it’s essential to determine the extent of the problem. First, check if the flange is indeed too high by placing a level across its surface. A flange that sits above the floor surface is an indication of it being too high.
Upon confirming the issue, you can proceed to the next step.
Remove the Toilet
To resolve the high flange problem, you will need to remove the toilet. Start by shutting off the water supply to the toilet and flushing it to empty the tank and bowl. Next, disconnect the water supply line and unscrew the bolts securing the toilet to the flange.
Carefully lift the toilet and place it on a protective covering to prevent damage.
Measure and Trim the Flange
Once the toilet is removed, you can focus on adjusting the height of the flange.
Measure the thickness of the flooring material or any other obstruction causing the flange to be too high. Using a hacksaw or reciprocating saw, trim the flange to the desired height. Ensure a clean cut, as any jagged edges may compromise the seal.
Attach a Flange Extension
If trimming the flange is insufficient to achieve the desired height, you can consider using a flange extension kit. These kits are readily available at hardware stores and typically include an extension piece along with corresponding screws or bolts.
Follow the manufacturer’s instructions to attach the extension securely, providing the necessary elevation for the flange.
Reset the Toilet
Once the flange has been suitably adjusted or extended, it’s time to reinstall the toilet. Ensure the area around the flange is clean and free of debris. Apply a new wax ring to the toilet flange, carefully align the holes on the base of the toilet with the flange bolts, and lower it into place.
Gently press down to create a proper seal. Reattach the nuts and bolts, being cautious not to overtighten them.
Test for Leaks and Stability
After resetting the toilet, turn on the water supply and allow the tank to fill. Inspect the connections for any signs of leakage. To check the stability, sit on the toilet and rock back and forth, ensuring it remains firmly in place.
If there are no leaks and the toilet is secure, congratulations! You have successfully addressed the issue of a high toilet flange.
Conclusion
Encountering a high toilet flange doesn’t have to be a major setback during your bathroom remodeling or repair project. By following these steps, you can effectively resolve this issue and ensure a properly functioning and secure toilet installation.
Remember to assess the situation, remove the toilet, adjust or extend the flange as needed, and reset the toilet with a new wax ring.
With patience and attention to detail, you’ll have your toilet back in position and functioning optimally in no time.
Leave a Reply